Q. Do the wings Fold?
A. No, The cost in weight and complexity makes this difficult.
Q. Can I cover the Rear Section?
A. Not and stay legal it would make the craft to fast...
Q. Do I need a seat cushion?
A. No the seat is quite comfortable and you get onboard ventilation!
Q. Can I use a plastic propeller?
A. Since no reduction drive exists this is not recommended.
Q. Can I use a rotax engine?
A. Yes, but you will have to watch the W&B and center of gravity.
Q. Can I paint it?
A. Only if the paint is less than 5 pounds based on my flying prototype.
Q. What are the wings made of?
A. All wood aircraft grade spruce.
Q. What are the wing ribs made of?
A. Made with 1/4th inch cap strips with and plywood gussetts glue and stapled. Staples are removed after the glue dries.
Q. What are the spars made of?
A. Thee quarter square spar caps with plywood webbing and intercostals at all ribs.
Q. What kind of glue do you use?
A. There are many good glues on the market, I use T-88
Q. What are the struts made of ?
A. They are 60-61 T6 aluminium inch and one quarter diameter 58th 1000 wall.
Q. Do you have materials kits available?
A. This is under consideration if enough interest is shown...
Return To The Home Page Copyright © 1999 by Leonard Milholland, All rights reserved. Information published here is for entertainment and general knowledge only and is not a recommendation as to how you should pursue your hobby. Our total limit to liability is to return the purchase price of the materials less shipping and handling if some conflict exists. No Warranties of merchantability or fitness for use are expressed or implied. The website is hosted at www.usastores.com, in Independence MO. Last Page revision 7-22-99.